All products will be shipped in 1-2 business days

How to Disassemble the K4?

1. Remove the screw from the frame (skip this if you have a plastic frame version keyboard).

Screw type for K4 version 2 frame: KB2.6*6mm (inner hex:2.0mm, hex nut: Ф4.2mm)

2. Take off the keycaps and remove the screw (total 15 pcs) on the PCB board as shown below;

Screw type for K4 version 2 plate: KA2.3*7mm (Nut: Ф3.8mm)

3. Pull the PCB board out as shown below(remember to take it off with a caution, do not break the switch place where the red highlight circle as shown below).

    Leave a Reply

    Your email address will not be published. Required fields are marked *

    en_USEnglish